Range Rover Evoque: Wheel Knuckle Rear Bushing

Special Tool(s)

204-620-01
Installer, Wheel Knuckle Bushing

204-620-02
Remover/Installer, Wheel Knuckle Bushing

204-620-03
Remover, Wheel Knuckle Bushing

LR-121
Hydraulic Cylinder 10t

Removal

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Remove the wheel and tire.

Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

3.

Range Rover Evoque. Rear Suspension

4.

Range Rover Evoque. Rear Suspension

5. CAUTION: Note the position of the component and mark the surrounding area to aid installation.

Range Rover Evoque. Rear Suspension

6. Remove the bushing.

Special Tool(s): LR-121, 204-620-02, 204-620-03

Range Rover Evoque. Rear Suspension

Installation

1. CAUTION: Make sure that the component is installed to the position noted on removal.

Range Rover Evoque. Rear Suspension

2. CAUTION: Make sure the correct special tool is used to install the bushings to the correct depth.

Install the bushing.

Special Tool(s): LR-121, 204-620-01, 204-620-02

Range Rover Evoque. Rear Suspension

3. Torque: 270 Nm

Range Rover Evoque. Rear Suspension

4. Torque: 110 Nm

Range Rover Evoque. Rear Suspension

5. Install the wheel and tire.

Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

READ NEXT:

 Rear Shock Absorber Vehicles With: Dynamic Suspension

General Equipment Suspension Spring Compressor Vise Removal WARNINGS: Make sure the spring compressor Safe Working Load (SWL) meets or exceeds the spring rating quoted in the Specifcations sectio

 Shock Absorber and Spring Assembly Vehicles With: Dynamic Suspension

Special Tool(s) JLR-204-804 Lever, Wheel Knuckle General Equipment Transmission jack Wooden Block Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspensi

 Spring Vehicles Without: Dynamic Suspension

Removal WARNINGS: Make sure the spring compressor Safe Working Load (SWL) meets or exceeds the spring rating quoted in the Specifcations section. Always follow the spring compressor manufacturer's i

SEE MORE:

 Engine Wiring Harness TD4 2.2L Diesel, Vehicles With: M66 6-Speed Manual Transmission AWD/M66 6-Speed Manual Transmission FWD

Removal CAUTIONS: Make sure that the wiring harness is not twisted or damaged on removal. Failure to follow this instruction may result in damage to the vehicle. Take extra care not to damage the wiring harness clips. NOTES: Some variation in the illustrations may occur, but the essential informa

 Audio Front Control Module (ACM)

Integrated Audio Module (ACM)   CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle. NOTES: If the co

© 2011-2025 Copyright www.rrevoque.org