Range Rover Evoque: Dynamic stability control (amber)
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Warning lamps / Dynamic stability control (amber)
Dynamic stability control (amber)
Illuminates briefly when the ignition is switched on and extinguishes when the engine is started. If the lamp flashes while driving, the DSC system is active. If the lamp illuminates continuously while driving, there is a fault with the DSC system. The vehicle can still be driven, but the DSC system will not activate under wheel spin or slide conditions.
Seek qualified assistance as soon as possible.
READ NEXT:
Dynamic stability control off (amber)
Dynamic stability control off (amber)
Illuminates when DSC is switched
off.
Deactivating DSC also reduces the
level of Electronic Traction Control intervention
and may lead to an increase in wh
Anti-lock braking system (amber)
Anti-lock braking system (amber)
Illuminates briefly when the
ignition is switched on. If the lamp
remains on or illuminates while
driving, there is a fault with the ABS system.
Drive with care
Airbag srs (amber)
Airbag srs (amber)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started. If the lamp illuminates while driving,
there is a fault with the airbag syst
SEE MORE:
Headphones
The volume control for each set of headphones
is adjusted on the headphones.
Press the channel selector button to cycle
through available channels. Select the channel
appropriate for the required screen.
Note: These headphones are not intended for
use by the driver or outside the vehicle.
Not
Engine Timing
Special Tool(s)
303-1565
Locking Tool, Camshaft
308-511
Installer, Transmission Output Shaft Seal
JLR-303-1594
Locking Tool, Driveplate
JLR-303-748
Locking Tool, Crankshaft
Activation
1.
2. Install the special tool.
Special Tool(s): JLR-303-748
3. Rotate the engine clockwise until the crankshaft
© 2011-2025 Copyright www.rrevoque.org
