Range Rover Evoque: Emergency brake assist (EBA)
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Brakes / Emergency brake assist (EBA)
If the driver rapidly applies the brakes, EBA automatically boosts the braking force to its maximum, in order to bring the vehicle to a halt as quickly as possible. If the driver applies the brakes slowly, but conditions mean that ABS operates on the front wheels, EBA will increase the braking force in order to apply ABS control to the rear wheels.
EBA stops operating as soon as the brake pedal is released.
The amber brake warning lamp illuminates briefly when the ignition is turned on.
A fault with the EBA system is indicated by the amber brake warning lamp illuminating and an associated warning message. Gently and safely stop the vehicle and seek qualified assistance.
READ NEXT:
Electronic brake distribution (EBD)
EBD controls the balance of braking forces
supplied to the front and rear wheels, in order
to maintain maximum braking efficiency.
If the vehicle has a light load (only the driver in
the vehicle f
Electric parking brake (EPD)
The parking brake operates on
the rear
wheels. Therefore, secure parking of
the vehicle is dependent on being on a
hard and stable surface.
Do not rely on the parking brake to
operate effectiv
Epb manual use
Epb manual use
1. To apply the parking brake, with the vehicle
stationary, pull up the lever and release it.
The parking brake warning
lamp will illuminate. It is
important to confirm that th
SEE MORE:
Event data recording
Event data recorders are capable of collecting
and storing short sequences of data during a
crash or near-crash event. The recorded
information may assist in the investigation of
such an event. The EDR may record
information about vehicle dynamics and safety
systems, potentially including such
Quarter Panel
Removal
NOTES:
Within this procedure there are 2 different options depending on type of
vehicle body and combination of replacement panels.
The quarter panel is manufactured from mild steel.
The rocker panel butt joint in option 2 must be MIG brazed due to the location
of boron reinforcements.
© 2011-2025 Copyright www.rrevoque.org
