Range Rover Evoque: Headlamp Adjustment
NOTE: The headlamp setting is 1.2 % below horizontal and parallel.
1. Align the headlamp beam setting equipment to one headlamp.
2. Switch the headlamps on and to dipped beam.
3. NOTE: NAS vehicles have vertical adjustment only.
- Adjust the headlamps with an Allen Key.
- Rotate the adjuster 'A' for horizontal alignment.
- Rotate the adjuster 'B' for vertical alignment.

4.
- To adjust the second headlamp, repeat the above procedure.
Front Fog Lamp Adjustment
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. NOTE: The fog lamp beam should be set at 2%
below the horizontal and parallel.
Check the fog lamp beam alignment.

2. Align the beam setting equipment 2. to one fog lamp.
3.

4. Adjust the fog lamp.

5. To adjust the second fog lamp, repeat the above procedure.
Front Fog Lamp LH
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the LH front wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and
Installation).
3. CAUTION: Take extra care not to damage the
component.

4.

5. NOTE: RH illustration shown, LH is similar.
Torque: 2 Nm

Installation
1. To install, reverse the removal procedure.
2. Check the fog lamp beam alignment.
Refer to: Front Fog Lamp Adjustment (417-01 Exterior Lighting,
General Procedures).
READ NEXT:
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2.
3.
4. NOTE: Some com
Principle of Operation
Three types of headlamp are available: Halogen, bi-xenon or Adaptive Front
Lighting System (AFS).
For a detailed description of the headlamps operation, refer to the relevant
Principle of Operation
For information on the description and operation of the system, refer to
relevant section of the workshop manual. REFER
to: (417-01 Exterior Lighting)
Note that the stoplamps w
SEE MORE:
Wherever possible avoid
using fuel
containing methanol.
Some fuels contain methanol (Methyl or wood
alcohol). If you use fuels containing methanol
the fuels must also contain co-solvents and
corrosion inhibitors for methanol. Also, do not
use fuels which contain more than 3%
methanol even
The towing eyes at the front
and rear
of the vehicle are designed for
on-road recovery only. If they are used
for any other purpose, it may result in
vehicle damage and serious injury.
The towing eyes are located behind panels in
the bumpers. Panel design will vary depending
on the vehic
© 2011-2025 Copyright www.rrevoque.org
