Range Rover Evoque: Lower Arm
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
NOTES:
RH illustration shown, LH is similar.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3. WARNING: Make sure that a new nut is installed. Torque: 60 Nm
4.
5. WARNING: Make sure that a new bolt is installed. Torque: 200 Nm
6. WARNING: Make sure that a new bolt is installed.
Torque:
Stage 1: 48 Nm
Stage 2: 180
READ NEXT:
Front Stabilizer Bar AWD
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTES:
Only use clean water as a lubricant for the bushing, if required.
Removal steps in this pro
Front Stabilizer Bar Bushing
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure
Wheel Knuckle
Special Tool(s)
205-754A
Splitter, Ball Joints
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
sus
SEE MORE:
Automatic transmission
The rotary drive selector rotates in either
direction. At engine start up, the selector
elevates out of its parked position.
1. To select D (Drive) or R (Reverse) gear,
apply the foot brake then rotate the drive
selector. The related LED by the selector
will illuminate.
Note: If pressure is
Jacking
General
WARNING: The
following instructions must be adhered to before raising the vehicle off the
ground:
Position vehicle on a solid, level surface.
Apply the parking brake.
Select 'P' - PARK on automatic transmission selector.
Select 'N' - Neutral on manual transmission.
WARNING: If
the
© 2011-2025 Copyright www.rrevoque.org
