Range Rover Evoque: Replacing remote control batteries

Replacing remote control batteries
Replacing remote control batteries

With the back of the remote control facing upwards, use a coin or similar implement to rotate the battery cover. Lift the cover off to reveal the battery compartment. Remove the old battery and, ensuring that the correct polarity is maintained, insert a replacement 3.3 volt, CR1/3N battery. Replace the cover and rotate it to lock it closed.

READ NEXT:

 Additional remote controls

A maximum of three controls can be programmed to each vehicle. Contact your Land Rover dealer to purchase additional units and have them programmed to your vehicle.

 Storage compartments

 Cup holders and storage

Cup holders and storage 1. Glovebox. 2. Inside the glovebox is a drop down storage area for the Owner’s Handbook pack. 3. Cubby box. 4. Sliding top to reveal cup holders. Do not drink, or u

SEE MORE:

 Wheel Knuckle

Special Tool(s) 205-754A Splitter, Ball Joints 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow halfshafts to hang unsupported at one end or joint damage will occur. Make

 Rear Side Member Closing Panel

Removal NOTES: The rear side member lower side extension is manufactured from DP600 with a mild steel mounting bracket. The panel is serviced less its weld studs. 1. The rear side member closing panel is replaced 2. For additional information relating to this repair procedure please see the foll

© 2011-2025 Copyright www.rrevoque.org