Range Rover Evoque: Anti-Lock Control - Stability Assist
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Brake System / Anti-Lock Control - Stability Assist
Accelerometer
Removal
NOTES:
Removal steps in this procedure may contain installation details.
LHD illustration shown, RHD is similar.
Vehicles with automatic transmission
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).
2. Torque: 9 Nm
Vehicles with manual transmission
3. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).
4.
5.
6. Torque: 9 Nm
Installation
1. To install, reverse the removal procedure.
2. If a new component has been installed, configure using Land Rover approved diagnostic equipment.
READ NEXT:
Power Steering AWD
Component Location
Steering gear
Rubber seal assembly
Heat shield
Overview
The vehicle is fitted with EPS (electric power steering), provided by a ZF
Servolectric steering gear unit with variab
SEE MORE:
Glass Roof Panel
Removal
CAUTIONS:
Always protect paintwork and glass when removing exterior components.
Always protect the interior components when removing body glass.
Measure all gaps between the glass roof panels before prior to removal to help
aid installation.
Lay the glass on felt covered supports. Do not
Wheel Knuckle
Special Tool(s)
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
Do not allow halfshafts to hang unsupported at one end or joint damage will
occur.
Make sure the halfshaft constant vel
© 2011-2025 Copyright www.rrevoque.org
