Range Rover Evoque: Commandshift™

To return to Sport mode after CommandShift has been selected, move the selector back to D then back to Sport mode. Transmission Commandshift Selected will appear in the message centre when the transmission is in CommandShift mode.

Note: In order to protect the engine, the transmission will automatically change up to prevent over-revving, or down if the engine is labouring.

READ NEXT:

 Kick-down

Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode. When the pedal is relaxed, normal gear changing will resume.

 Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console. If the engine is sw

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

SEE MORE:

 Deselecting valet mode

If Valet mode is active when you enter the vehicle, touch the Valet button to view the Valet mode screen. Enter your four digit PIN and touch the OK button. Valet mode is deactivated is displayed. - The tailgate will return to the previously set security requirement. - All touch screen funct

 Engine - Diagnosis and Testing

Principles of Operation For a detailed description of the engine system, refer to the relevant Description and Operation section in the workshop manual. REFER to: (303-01B Engine - GTDi 2.0L Petrol) Inspection and Verification CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptabl

© 2011-2025 Copyright www.rrevoque.org