Range Rover Evoque: Replacing remote control batteries

Replacing remote control batteries
Replacing remote control batteries

With the back of the remote control facing upwards, use a coin or similar implement to rotate the battery cover. Lift the cover off to reveal the battery compartment. Remove the old battery and, ensuring that the correct polarity is maintained, insert a replacement 3.3 volt, CR1/3N battery. Replace the cover and rotate it to lock it closed.

READ NEXT:

 Additional remote controls

A maximum of three controls can be programmed to each vehicle. Contact your Land Rover dealer to purchase additional units and have them programmed to your vehicle.

 Storage compartments

 Cup holders and storage

Cup holders and storage 1. Glovebox. 2. Inside the glovebox is a drop down storage area for the Owner’s Handbook pack. 3. Cubby box. 4. Sliding top to reveal cup holders. Do not drink, or u

SEE MORE:

 Driveshaft

Torque Specifications Driveshaft TD4 2.2L Diesel, Vehicles Without: Diesel Particulate Filter (DPF) Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Exhaust System (309-00B, Removal and Installation). 3. CAUTIONS: Mark the position o

 Inner Back Panel Assembly

Removal NOTES: The inner back panel assembly is manufactured from mild steel. The panel is serviced less its weld studs. The new service panel is not fully spot welded when supplied. It is necessary to remove a section of one rear lamp mounting panel to enable removal and installation of the inn

© 2011-2025 Copyright www.rrevoque.org