Range Rover Evoque: Window reset
If the battery is disconnected or the power
supply is interrupted, the windows must be
reset.
Once the power supply is restored, reset as
follows:
1. Close the window fully.
2. Release the switch, then lift it to the close
position and hold for 1 second.
3. Repeat the procedure on each window.
READ NEXT:
Closing a window or roof
blind onto
any part of the body can result in
serious injury.
Before closing a window or the roof
blind, ensure that no occupants have
any part of their body in a posi
if a resonance or booming sound occurs when
a rear window is open, lowering an adjacent
front window by approximately 25mm (1 inch)
will eliminate the condition.
SEE MORE:
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: The procedure must be carried out on
both sides.
NOTE: LH illustration shown, RH is similar.
Torque: 1.9 Nm
Vehicles with manual transmission
2. Refer to: Gearshift Lever Knob (308-06 Manual
Tr
Removal
NOTES:
The fender apron panel front reinforcement is manufactured from RP220 and
mild steel.
The panel is serviced less its weld studs
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on an
approved alignment jig.
2. The front side member and fender a
© 2011-2025 Copyright www.rrevoque.org
