Range Rover Evoque: Anti-Lock Control - Stability Assist

Accelerometer

Removal

NOTES:

Removal steps in this procedure may contain installation details.

LHD illustration shown, RHD is similar.

Vehicles with automatic transmission

1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).

2. Torque: 9 Nm

Range Rover Evoque. Anti-Lock Control - Stability Assist

Vehicles with manual transmission

3. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).

4.

Range Rover Evoque. Anti-Lock Control - Stability Assist

5.

Range Rover Evoque. Anti-Lock Control - Stability Assist

6. Torque: 9 Nm

Range Rover Evoque. Anti-Lock Control - Stability Assist

Installation

1. To install, reverse the removal procedure.

2. If a new component has been installed, configure using Land Rover approved diagnostic equipment.

READ NEXT:

 Steering System

 Power Steering

 Power Steering AWD

Component Location Steering gear Rubber seal assembly Heat shield Overview The vehicle is fitted with EPS (electric power steering), provided by a ZF Servolectric steering gear unit with variab

SEE MORE:

 Jacking

General WARNING: The following instructions must be adhered to before raising the vehicle off the ground: Position vehicle on a solid, level surface. Apply the parking brake. Select 'P' - PARK on automatic transmission selector. Select 'N' - Neutral on manual transmission. WARNING: If the

 Front/Rear Door Window Glass

Front Door Window Glass Special Tool(s) 501-114 Release Lever, Door Glass Removal NOTE: Removal steps in this procedure may contain installation details. 1. Torque: 1 Nm 2. Special Tool(s): 501-114 3. Installation 1. NOTE: An audible click is heard when the clips are fully latched. To install, re

© 2011-2025 Copyright www.rrevoque.org