Range Rover Evoque: Front Seat Height Adjustment Motor
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. WARNING: To avoid accidental deployment, the restraints control module backup power supply must be depleted. Wait at least two minutes after disconnecting the battery ground cable(s) before commencing any repair or adjustment to the supplemental restraint system (SRS), or any component(s) adjacent to the SRS sensors.
Failure to follow these instructions may result in personal injury.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
3. Refer to: Front Seat Control Switch (501-10 Seating, Removal and Installation).
4. Refer to: Front Seat (501-10 Seating, Removal and Installation).
5. CAUTION: Note the fitted position of the component prior to removal.
Vehicles with sports seats
6.
7. CAUTION: Note the fitted position of the component prior to removal.
Vehicles with heated front seats
8. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
Non NAS vehicles
9. CAUTION: Make sure that the component is aligned and attached as shown.
NAS vehicles
10.
All vehicles
11. NOTE: If equipped.
12.
13.
14. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
Torque: 28 Nm
15. Torque: 28 Nm
16. NOTES:
Use a suitable tool to remove the circlips from the seat cushion frame bolts.
Note the orientation of the components.
Right-hand shown, left-hand similar.
Repeat the procedure for the other side.
17. NOTES:
Right-hand shown, left-hand similar.
Repeat the procedure for the other side.
Torque: 20 Nm
18.
19. NOTES:
Note the orientation of the components.
Right-hand shown, left-hand similar.
20.
21. Torque: 10 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Front Seat Cushion Cover
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Prior to carrying out the step by step procedure below, Steps 2
and 3 must be followed for knowledge on
Rear Seat Cushion Cover
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Prior to carrying out the step by step procedure below, Steps 2
and 3 must be followed for knowledge on how to correc
Front Seat Backrest Heater Mat
Removal
WARNINGS:
To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before
repairing or replacing any air bag supplemental restraint system (SRS)
SEE MORE:
Emergency brake assist (EBA)
If the driver rapidly applies the brakes, EBA
automatically boosts the braking force to its
maximum, in order to bring the vehicle to a halt
as quickly as possible. If the driver applies the
brakes slowly, but conditions mean that ABS
operates on the front wheels, EBA will increase
the braking
Replacement sensor
Should the sensor require replacing, it should
be carried out by a Dealer/Authorised Repairer.
A replacement sensor must be fitted to a
running wheel in order to be recognised by the
system. The vehicle needs to be stationary for
15 minutes during the sensor fitment before
the system is ready
