Range Rover Evoque: Opening and closing the bonnet

Opening and closing the bonnet
Opening and closing the bonnet

Opening

1. Pull the bonnet release lever, located in the left-hand front footwell.

2. Lift the bonnet safety catch lever, located below the centre point of the bonnet, then raise the bonnet.

Closing

retained Do not drive with the bonnet retained by the safety catch alone.

3. Lower the bonnet until the safety catch engages. Using both hands, press the bonnet down until the catches click. Check that both catches are engaged by trying to lift the front edge of the bonnet.

READ NEXT:

 Poisonous fluids

Fluids used in motor vehicles are poisonous and should not be consumed or brought into contact with open wounds. For your own safety, always read and obey all instructions printed on labels and co

 Used engine oil

Prolonged contact with engine oil may cause serious skin disorders, including dermatitis and cancer of the skin. Always wash thoroughly after contact. It is illegal to pollute drains, water co

 Engine compartment overview

Engine compartment overview 2.0L petrol engine 1. Brake/clutch fluid reservoir caps (beneath covers): A. Left-hand drive vehicles. B. Right-hand drive vehicles. 2. Engine oil filler cap. 5. O

SEE MORE:

 Fuel Charging and Controls - Component Location, System Operation and Component Description

Component Location COMPONENT LOCATION Overview OVERVIEW The 2.0L GTDi engine is equipped with a high-pressure direct injection system controlled by the ECM (engine control module). A high-pressure fuel pump delivers a uniform level of pressure to the shared fuel rail, which serve all 4 fuel injec

 Spare Wheel Well

Removal NOTES: The spare wheel well is manufactured from mild steel, it includes the spare wheel retaining bracket. The panel is serviced less its weld studs 1. The spare wheel well is replaced in conjunction with: Rear bumper cover Rear bumper Back panel Rear bumper mounting LH & RH Rea

© 2011-2025 Copyright www.rrevoque.org