Range Rover Evoque: Radiator
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
3. Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging - GTDi 2.0L Petrol (412-00 Climate Control System - General Information, General Procedures).
4. Refer to: Condenser - GTDi 2.0L Petrol (412-01 Climate Control, Removal and Installation).
5. Torque: 5 Nm
6.
7.
8. Torque: 5 Nm
9.
10.
11. CAUTION: Take extra care not to damage the component.
12. NOTE: Do not disassemble further if the component is removed for access only.
13. Torque: 3 Nm
14. NOTE: This step is only required if a new component is installed.
15.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Cooling Fan
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. WARNING: Make sure
Cooling System Partial Draining, Filling
and Bleeding
Draining
CAUTIONS:
The engine cooling system must be maintained with the correct
concentration and type of anti-freeze solution to
prevent corrosion and frost damage. Failure to follow this instructi
Engine Cooling - Diagnosis and Testing
Principles of Operation
For a detailed description of the cooling system, refer to the relevant
Description and Operation section in the workshop
manual. REFER to: (303-03B Engine Cooling - GTDi 2.0L
SEE MORE:
Front Wheel Bearing
Special Tool(s)
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
204-727A
Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-807
Installer, Front Wheel Bearing
JLR-204-808
Installer, Front Wheel Bearing
General Equipment
Copper Hammer
Hydraulic press
Transmission Vehicles With: M66 6-Speed
Manual Transmission FWD - Installation
Installation
Special Tool(s)
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. NOTE: This step is only required if previously
removed.
2. NOTE: This step is only
