Range Rover Evoque: Rear Door Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 1.3 Nm

2. Torque: 6 Nm

3. Torque: 6 Nm

4.

5.

6.

7. NOTE: Do not disassemble further if the
component is removed for access only.

8. Torque: 0.6 Nm

9.

10. Torque: 1 Nm

11.

Installation
1. To install, reverse the removal procedure.
Liftgate Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. NOTE: Make sure the two metal clips are removed
from the liftgate.

3. NOTE: Do not disassemble further if the
component is removed for access only.

Installation
1. To install, reverse the removal procedure.
READ NEXT:
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Vehicles with glass roof panel shown, vehicles without glass roof panel similar.
All vehicles
1. Refer to: Windshield
Engine Cover GTDi 2.0L Petrol
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Do not disassemble further if the
component is removed for access only.
Inst
CAUTION: LH illustration shown, RH is similar.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1.
2.
3.
4. Torque: 1.4 Nm
5. Torque: 20 Nm
6. NOTE: LH side o
SEE MORE:
Ensure that the areas around
air intakes
and the front grille are clean and clear of
debris. Pay particular attention to the
lower grille and radiator. Failure to do
so may cause the engine to overheat,
leading to severe engine damage.
Ensure that the vehicle underside is cleaned as
soon
1. WARNING: Make sure to support the vehicle with axle stands.
CAUTION: Make sure the vehicle is on a flat level surface.
Raise and support the vehicle.
2. No provision is made to fully drain the rear differential.
During repair procedures, fluid will be lost. A container
should be positioned to c
© 2011-2025 Copyright www.rrevoque.org
