Range Rover Evoque: Rolling re-start
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Rolling re-start
If the engine is switched off while the vehicle is moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and then press the engine START/STOP button.
When the engine re-starts, select transmission position D.
Manual transmission - depress the clutch and then press the engine START/STOP button.
When the engine re-starts, select an appropriate forward gear.
READ NEXT:
Keyless start backup
If the vehicle has been unlocked using the
emergency key blade or the Smart Key is not
detected by the vehicle, it will be necessary to
use the keyless start backup to disarm the
alarm and start t
Stop/start (manual transmission only)
The Stop/Start system has been designed to
improve fuel efficiency. The system is
automatically activated when the ignition is
switched on.
When the engine has been stopped by the
stop/start syst
Conditions preventing automatic engine stop
The engine will not automatically stop if:<>
- the external temperature is below approximately 0°C (32°F)
- the external temperature is above approximately40°C (104°F)
- engine has not re
SEE MORE:
Fender Apron Upper Panel
Removal
NOTES:
The fender apron upper panel is manufactured from mild steel.
The service panel is serviced not fully spot welded.
There is an NVH component on this panel, it is serviced on the new panel.
1. The fender apron upper panel is replaced in conjunction with:
Front bumper cover
Hood
H
Transmission Vehicles With: M66 6-Speed
Manual Transmission FWD - Removal
Removal
Special Tool(s)
205-857
Remover, Halfshaft
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
General Equipment
Transmission jack
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refe
© 2011-2025 Copyright www.rrevoque.org
