Range Rover Evoque manuals

Range Rover Evoque: Switching on the ignition

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Switching on the ignition

To turn on the ignition without starting the engine:
- Do not depress the brake/clutch pedal, - Press the START/STOP button and hold until the warning lamps illuminate, then release the button.

applied when If the brake/clutch pedal is applied when the start/stop button is pressed, the engine will start.

READ NEXT:

 Engine starting

Never start the engine, or leave it running, when the vehicle is in an enclosed space. Exhaust gasses are poisonous and can cause unconsciousness and death if inhaled. If the engine fails to

 Engine starting: automatic transmission

1. A valid Smart Key must be inside the vehicle. 2. Make sure the gear selector is in P or N. 3. Firmly depress the brake pedal. 4. Press and release the start button. The engine will crank autom

 Engine starting: manual transmission

Note: Do not press the accelerator pedal when starting the engine. 1. A valid Smart Key must be inside the vehicle. 2. Fully depress the clutch pedal. 3. Press and release the start button. For

SEE MORE:

 Glass Roof Panel Blind Motor

Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is always correct. All vehicles 1. NOTE: The step must be carried out on both sides. Refer to: A-Pillar Trim Panel (501-05 Interior Trim and

 Engine Control Module (PCM)

Engine Control Module 2.2L - I4 - DW12c TD4  CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.  

© 2011-2025 Copyright www.rrevoque.org