Range Rover Evoque: Transfer Case Fluid Level Check

CAUTION: The fluid filler plug is not a fluid level plug.

NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).

3. CAUTION: Make sure that the area around the component is clean and free of foreign material.

NOTE: Remove and discard the sealing washer.

4. CAUTION: The fluid filler plug is not a fluid level plug. Fill the transfer case with the recommended fluid.

Refer to: Specifications (308-07B Transfer Case - Vehicles With: AWF21 6-Speed Automatic Transmission/M66 6-Speed Manual Transmission AWD, Specifications).

5. NOTE: Install a new sealing washer. Torque: 35 Nm

6. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).

Power Transfer Unit GTDi 2.0L Petrol

Removal

NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Air Cleaner Intake Pipe (303-12B Intake Air Distribution and Filtering - GTDi 2.0L Petrol, Removal and Installation).

3. Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Front Drive Halfshafts, Removal and Installation).

4. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).

5. Torque: 24 Nm

6. CAUTIONS: Mark the position of the driveshaft flange in relation to the drive pinion flange.

Torque: 40 Nm

7. CAUTION: Take extra care not to damage the component.

NOTE: LH illustration shown, RH is similar.

8. NOTE: LH illustration shown, RH is similar.

Remove the RH front wheel arch liner.

9. CAUTIONS: Discard the bolt.

Make sure that a new bolt is installed.

Torque:

• Stage 1: 50 Nm
• Stage 2: 180

READ NEXT: