Range Rover Evoque: Isofix anchor points (not Australia)

restraints Do not attempt to fit ISOFIX restraints to the centre rear seating position.
The anchor bars are not designed to hold an ISOFIX restraint in this position.
If the restraint is not correctly anchored, there is a significant risk of injury to the child in the event of a collision or emergency braking.

Both of the outer seat positions on the rear seat are equipped to accept ISOFIX restraints.

This symbol is shown on a label

This symbol is shown on a label sewn into the seats to indicate the position of the ISOFIX lower anchorages.

READ NEXT:

 Isofix child seat positions

Isofix child seat positions - IUF = Suitable for ISOFIX forward child restraint systems of universal category approved for use in the mass group. - IL = These ISOFIX child restraint systems are

 Booster cushions

In a situation where a child is too large to fit into a child safety seat but is still too small to safely use just the three point belt, a booster seat is recommended for maximum safety. Follow t

 Installing an isofix child seat

Installing an isofix child seat To install an ISOFIX child seat: 1. Locate the ISOFIX locking mechanism. 2. Slide the child seat into the locking mechanism. 3. If an upper tether is fitted to t

SEE MORE:

 Inner Quarter Panel and Wheelhouse

Removal NOTES: The inner quarter panel and wheelhouse is manufactured from mild steel. The aid of a second technician is required to remove, offer up and align the inner quarter panel and wheelhouse. The service panel is not fully welded. 1. In this procedure, to make sure the vehicle is correctl

 Fender Apron Panel Reinforcement

Removal NOTE: The fender apron panel reinforcement is manufactured from mild steel. 1. 2. For additional information relating to this repair procedure please see the following: For additional information, refer to: Health and Safety Precautions (100-00 General Information, Description and Operat

© 2011-2025 Copyright www.rrevoque.org