Range Rover Evoque: Block Heater
Removal
1. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
2. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).
3. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
4. NOTE: Measure and mark a 70mm section of the pipe using the clamp as a guide.
5. NOTE: Discard the bolt and clamp.
Installation
1. Torque: 20 Nm
2. Torque: 6 Nm
3. NOTE: Using a suitable tool, cut a 70mm gap from the coolant pipe.
4. Torque: 3 Nm
5. CAUTION: Protect the surrounding paintwork and body from the movement of the cutting blades.
NOTE: Following the indent on the bumper and using a suitable tool, cut a 26mm hole in the front bumper cover.
6.
7. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
8. CAUTION: Make sure the retaining clip is secured correctly.
9.
10. NOTE: Make sure all ground connections are correctly installed. Torque: 10 Nm
11. Fill the engine coolant and test the block heater for correct operation.
Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
12. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).
READ NEXT:
Fuel Charging and Controls - Component Location, System Operation and Component Description
Component Location
COMPONENT LOCATION
Overview
OVERVIEW
The 2.0L GTDi engine is equipped with a high-pressure direct injection system
controlled by the ECM (engine control
module). A high-pressure f
Throttle Body
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some illustrations may show the engine removed for clarity.
1. WARNING: Make sure to support the vehicle with axle sta
SEE MORE:
Torque Converter Seal GTDi 2.0L Petrol
Special Tool(s)
307-597
Installer, Torque Converter Seal
307-613
Holding Pins, Torque Converter
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
Engine - Component Location, System Operation and Component
Description
Component Location
EXTERNAL VIEW
Overview
OVERVIEW
The 2.0L Gasoline Turbocharged Direct Injection (GTDi) engine is an in-line,
double overhead camshaft, 4 cylinder engine,
which is transverse mounted in the engine compartment. The engine weight is kept
to a minimum by using aluminum for
the cyli
