Range Rover Evoque: Blower Motor LHD AWD/LHD FWD
Special Tool(s)
412-140
Remover/Installer, Blower Motor
Removal
NOTES: Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. NOTE: The recirculation blend door must be closed in order for the removal of the recirculation blend door housing. Activate recirculation.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation).
4. Refer to: Central Junction Box (CJB) (418-00 Module Communications Network, Removal and Installation).
5.
6.
7.
8. Torque: 10 Nm
9.
10.
11.
12.
13. Special Tool(s): 412-140
14.
15. CAUTION: Make sure that the special tool is correctly located.
NOTE: With assistance remove the component.
Installation
1.
2.
3. To install, reverse the removal procedure.
READ NEXT:
Blower Motor RHD AWD/RHD FWD, RHD
Special Tool(s)
412-140
Remover/Installer, Blower Motor
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essenti
Climate Control Assembly
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: LH illustration shown, RH is similar.
NOTE: The procedure must be carried out on both
sides.
Evaporator LHD
Removal
NOTES:
The removal of this component involves cutting an aperture in the evaporator
housing wall and cutting through the
high and low pressure A/C lines. A service repair kit is supplied to c
SEE MORE:
After towing on four wheels
1. Apply the parking brake. For vehicles with
an automatic gearbox, apply the footbrake
and then select Park position.
2. Switch off the ignition and remove the
Smart Key from the vehicle.
3. Remove the towing attachment and refit
the cover panel to the front bumper.
Use extreme caution when
If the engine fails to start
Note: If the engine fails to crank when the
START/STOP button is pressed and there has
been a recent collision, seek qualified
assistance.
If the engine fails to crank, or fails to start,
consult your Dealer/Authorised Repairer.
Diesel engines:
If the engine persistently fails to start, make
