Range Rover Evoque: High beam assist
This feature of the Xenon lighting automatically selects and deselects high beam, under specific conditions of road lighting and in the absence of other vehicle’s lights. The system is only active when the ambient light drops below a predetermined level.
Note: It is not recommended that high beam assist is used while driving off road.
For High beam assist to become operational, the main lighting switch must be in the AUTO position (5), with low beam headlamps selected.
High beam assist will activate only when the vehicle speed exceeds 40km/h (25mph). The system will deactivate when vehicle speed drops below 24km/h (15mph).
To manually select high beam, move the stalk to the high beam position as normal. To return to High beam assist, move the stalk back to the central position.
To manually override to low beam from high beam, pull the stalk to the flash position (2) and High beam assist will be cancelled. To return to High beam assist, push the stalk to the high beam position (1) and then return it to the central position.
A green lamp in the instrument pack illuminates when High beam assist is selected.
To turn off High beam assist, turn the main lighting control from Auto to headlamps.
This feature can be disabled/enabled via the Vehicle settings menu. See 56, VEHICLE INFORMATION AND SETTINGS MENU.
Note: The following may affect the operation of
High beam assist:<>
- Highly reflective road signs.
- Vehicles with dim headlamps.
- Adverse weather conditions.
- Dirty sensor.
- Dirty, damaged, or misted windscreen.
Note: The system cannot be relied upon to activate or de-activate high beam in all possible circumstances. It remains the driver’s responsibility to ensure correct use of the headlamps at all times.
Note: Ensure that the forward facing sensors on the back of the rear view mirror are not blocked or obstructed.
READ NEXT:
Auto lamps windscreen wiper detection
If Auto lamps is selected and the windscreen
wipers are switched on for 20 seconds or
more, the side lamps, tail lamps and
headlamps will switch on automatically. When
the wipers are switched off,
Condensation
Misting of lamp lenses can occur under some
atmospheric conditions. This will not affect the
performance of the lamps and will clear during
normal operation.
Headlamps - driving abroad
The headlamp beam pattern is suitable for
driving on either side of the road.
SEE MORE:
Daytime running lamps
Daytime running lamps are LED lamps.
With the lighting control in the OFF position or
in AUTO position while lighting conditions do
not require headlamps on, then daytime
running lamps will switch on automatically
under the following conditions:
- The engine is running.
- The gear selector is
Topping up the washer fluid
The washer reservoir supplies the front and
rear screen washer jets and headlamp washer
jets.
Check and top-up the reservoir level at least
every week. Always top-up with screen washer
fluid to prevent freezing.
Operate the washer switches periodically to
check that the nozzles are clear and
