Range Rover Evoque: Airbag deployment effects
When an airbag inflates, a
fine
powder is released. This is normal
and not an indication of a malfunction.
The powder may cause irritation to the
skin and should be thoroughly flushed
from eyes and any cuts or abrasions. If
breathing difficulty is experienced,
leave the vehicle if possible or open
the windows or doors to allow fresh air
in.
Airbags inflate at high speed and can
cause injuries. To minimise the risk of
injury, ensure that all occupants wear
correctly positioned seat belts, sit
correctly in the seats and position the
seats as far back as is practicable.
Airbag deployment is accompanied by
a very loud noise which may cause
discomfort and temporary loss of
hearing.
After inflation, some airbag
components will be very hot. Do not
touch the airbag components until
they have cooled sufficiently.
READ NEXT:
Airbag warning lamp
Airbag warning lamp
The airbag warning lamp is
mounted in the instrument pack
and will illuminate as a bulb check
when the ignition is turned on.
If the warning lamp indicates
that a
fault
Airbag service information
Do not attempt to service,
repair,
replace, modify, or tamper with, any
part of the SRS. This includes wiring
or components in the vicinity of SRS
components. Doing so may cause the
system to
Disability modifications
Occupants with disabilities which may require
modification of the vehicle, must contact a
Dealer/Authorised Repairer before any
modifications are made.
SEE MORE:
Active
On-demand Coupling Control Module
Rear Differential Control Module (RDCM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
NOT
Bolt and Nut Identification
An ISO metric bolt or screw made of steel and larger than 6 mm in diameter
can be identified by either of the symbols ISO
M or M embossed or indented on top of the bolt head.
In addition to marks identifying the manufacturer, the top of the bolt head
is also marked with symbols indicating the
st
