Range Rover Evoque: Before programming
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best results, fit a new battery to the hand-held transmitter of the garage door opener (or other device) before programming.
If your garage door opener receiver (located in the garage) is equipped with an antenna, ensure that the antenna is hanging straight down.
READ NEXT:
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6
Rolling code device equipment programming
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
1. At the garage d
Reprogramming a single garage door opener button
To programme a device to a previously
programmed button:
1. Press and hold the desired
pre-programmed HomeLink button for at
least 20 seconds, but no longer than 30
seconds, until the indicator l
SEE MORE:
Active On-Demand Coupling Vehicles With:
M66 6-Speed Manual Transmission AWD
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise the vehicle on a lift.
2. Remove the exhaust system.
Refer to: Exhaust System (309-00B Exhaust System - TD4 2.2L
Diesel, Removal and Installation).
3. CAUTION: Make sure that the driveshaft is
supported with suitable retai
Headphones
The volume control for each set of headphones
is adjusted on the headphones.
Press the channel selector button to cycle
through available channels. Select the channel
appropriate for the required screen.
Note: These headphones are not intended for
use by the driver or outside the vehicle.
Not
© 2011-2025 Copyright www.rrevoque.org
