Range Rover Evoque: Diesel engined vehicles
Do not use RME (bio-diesel)
except in
the case of those proprietary diesel
fuels which contain a mix of up to 7%.
Land Rover vehicles can accept no
responsibility for damage caused by
using RME in concentrations greater
than 7%.
Use only high quality diesel fuel according to EN590 or equivalent.
The quality of diesel fuel is variable, depending on geographic location. Always use premium or the highest quality fuel available in your locality. High quality fuel ensures a longer life for your engine components. Lower grade fuel contains higher levels of sulphur, which is detrimental to engine components. If low quality fuel is used, light coloured smoke may be evident at the exhaust.
Prolonged use of additives is not recommended. Do not add paraffin or petrol to diesel fuels.
If you inadvertently fill
your vehicle with
petrol instead of diesel, do not attempt
to start the engine. Contact your Dealer/
Authorised Repairer immediately.
Land Rover can accept no responsibility
for any damage caused by running your
vehicle with petrol or vegetable oil in the
fuel tank.
READ NEXT:
Sulphur content
If your vehicle is fitted
with a Diesel
Particulate Filter (DPF) the maximum
Sulphur content must not exceed
0.005%. Using an incorrect fuel will
cause serious damage to the DPF.
The Sulphur c
Running out of fuel
Avoid running out of fuel.
If the vehicle does run out of fuel, a minimum
of 4 litres (0.9 gallons) will be required to
restart the engine. The vehicle will need to be
driven 1.6-5 km (1-3 miles)
Fuel filler flap
Take note of all warnings
and
instructions given on the label affixed
to the inside of the filler flap.
The fuel filler flap is located on the right-hand
side of the vehicle, at the rear.
1. I
SEE MORE:
Front Wheel Bearing
Special Tool(s)
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
204-727A
Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-807
Installer, Front Wheel Bearing
JLR-204-808
Installer, Front Wheel Bearing
General Equipment
Copper Hammer
Hydraulic press
Lower Arm
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTES:
RH illustration shown, LH is similar.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the ve
