Range Rover Evoque: Epb manual use

Epb manual use
Epb manual use

1. To apply the parking brake, with the vehicle stationary, pull up the lever and release it.

The parking brake warning

The parking brake warning lamp will illuminate. It is important to confirm that the lamp is continuously illuminated (not flashing), as this indicates the brake has been correctly applied.

If the lever is operated when the vehicle speed is less than 3km/h (2mph) the vehicle will be brought to an abrupt stop.

The stop lamps will not be illuminated.

If a fault is detected the warning lamp will flash and a PARKBRAKE message will be displayed in the message centre.

Note: The red brake warning indicator will continue to be illuminated for at least ten seconds after the ignition has been turned off.

2. To release the parking brake, press the brake pedal and press down on the EPB lever.

parking Driving the vehicle with the parking brake applied, or repeated use of the parking brake to slow the vehicle, may cause serious damage to the brake system.

In an emergency, with the vehicle travelling more than 3km/h (2mph), pulling on the EPB lever and holding gives a gradual reduction in speed. The brake warning indicator will illuminate accompanied by a warning tone and a PARKBRAKE message appearing in the message centre. The stop lamps will illuminate.

READ NEXT:

 Epb automatic use

EPB will be applied automatically if the ignition is switched off and the vehicle speed is below 3km/h (2mph). To prevent automatic operation, when the vehicle is stationary, press and hold the EP

 Epb warning indicators

If the system detects a fault with the EPB, the amber brake warning indicator will illuminate accompanied by a message on the message centre. If the system detects a fault while EPB is operating,

 Cruise control

SEE MORE:

 Windscreen wipers

Windscreen wipers 1. Rotate the collar to adjust the intermittent period. The intermittent delay period will vary and is controlled by either vehicle speed or a rain sensor. The control must be in position (4) to be operational. This is a dealer configurable option. 2. High speed wipe. 3.

 Tyre care

Do not drive the vehicle if a tyre is damaged, excessively worn, or incorrectly inflated. Avoid contaminating the tyres with vehicle fluids as they may cause damage to the tyre. Avoid spinning the wheels. The forces released can damage the structure of the tyre and cause it to fail. If w

© 2011-2025 Copyright www.rrevoque.org