Range Rover Evoque: Fuel Pump
Removal
WARNING: This procedure involves fuel handling. Be prepared for fuel spillage at all times and always observe fuel handling precautions. Failure to follow these instructions may result in personal injury.
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Refer to: Engine Cover - GTDi 2.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).
3. Refer to: Air Cleaner Intake Pipe (303-12B Intake Air Distribution and Filtering - GTDi 2.0L Petrol, Removal and Installation).
4.
5.
6. CAUTION: Discard the fuel pipe.
7.
8.
9.
10.
11. CAUTION: Discard the bolts.
Installation
1. CAUTIONS:
Make sure that the mating faces are clean and free of foreign material.
Apply sealant WSE-M4G323-A6 in a 5mm diameter on the gasket as illustrated. Install the gasket immediately after applying the sealant without smearing the sealant.
2. CAUTION: Make sure that the mating faces are clean and free of foreign material.
Torque: 20 Nm
3. CAUTIONS:
Install all the bolts finger tight before final tightening.
Make sure that new bolts are installed.
NOTE: Lubricate the O-ring seal with clean engine oil.
Torque:
- Stage 1: 5 Nm
- Stage 2: 55
READ NEXT:
Fuel Charging and Controls - Turbocharger - GTDi 2.0L Petrol
Torque Specifications
Turbocharger
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always
Accessory Drive - GTDi 2.0L Petrol
Torque Specifications
Accessory Drive Belt
Removal
NOTE: Some illustrations may show the engine removed for clarity.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery
Starting System - GTDi 2.0L Petrol
Starting System - Component
Location
COMPONENT LOCATION
Solenoid
12V supply from battery
Solenoid power supply from Battery Junction Box (BJB)
Starter motor
Pinion gear
Starting System - Overv
SEE MORE:
Rear seat access (coupe models)
The front seats tilt and power slide forwards for
entry to and exit from the rear seats. Operation
is controlled by a lever and switch.
1. Lift the locking lever and pivot the seatback
forwards.
2. Press the front of the switch to power the
seat forwards.
3. To return the seat, pivot the se
Daytime running lamps
Daytime running lamps are LED lamps.
With the lighting control in the OFF position or
in AUTO position while lighting conditions do
not require headlamps on, then daytime
running lamps will switch on automatically
under the following conditions:
- The engine is running.
- The gear selector is
