Range Rover Evoque: Using traction devices

heavy Only use traction devices in heavy snow conditions, on hard road surfaces.
Dynamic Stability Control (DSC) must be switched off when using traction devices.
Never exceed 50 km/h (30 mph) when traction devices are fitted.
Never fit traction devices to a temporary use spare wheel.

Land Rover approved traction devices may be used to improve traction on a hard road surface in heavy snow conditions. They should not be used in off-road conditions.

If it becomes necessary to fit traction devices, the following points must be observed: - Only Land Rover approved traction devices should be used on the vehicle. Only Land Rover approved traction devices have been tested to ensure that they do not cause damage to the vehicle. Contact your Land Rover Dealer/Authorised Repairer for information.

- The wheels and tyres fitted must conform to the specifications of the original equipment.

- Do not fit traction devices to 18, 19 or 20inch diameter wheels.

- Single sided Spike-spyder traction devices or snow chains can be fitted to only the front wheels of vehicles fitted with 17inch diameter wheels.

- Always read, understand and follow the traction device manufacturer's instructions.

- Avoid tyre/vehicle damage, by removing the traction devices as soon as the conditions allow.

READ NEXT:

 Tpms inflation pressure compensation

If your vehicle is fitted with 18, 19 or 20 inch wheels with TPMS, they can be replaced with 17 inch wheels with TPMS, so enabling the use of snow chains or traction devices. Tyre pressures of veh

 Vehicle recovery

 Recovery

The method for recovery/ transportation of the vehicle is on a transporter or trailer designed for that purpose. Ensure that transportation is carried out by suitably qualified person and that the

SEE MORE:

 Gracenote® end user license agreement

This application or device contains software from Gracenote, Inc. of Emeryville, California (“Gracenote”). The software from Gracenote (the “Gracenote Software”) enables this application to perform disc and/or file identification and obtain music-related information, including name, ar

 Halfshaft Seal RH Vehicles With: M66 6-Speed Manual Transmission AWD

Special Tool(s) 303-1300 Remover, Crankshaft Seal 303-882 Installer, Halfshaft Seal Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Front Drive Halfshafts, Removal and Installation). 3. CA

© 2011-2025 Copyright www.rrevoque.org