Range Rover Evoque: Front Lower Arm

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Suspension / Rear Suspension / Front Lower Arm

Removal

NOTES:

Some variation in the illustrations may occur, but the essential information is always correct.

Front wheel drive transmission illustrations shown, all wheel wheel drive transmission is similar.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

3.

Range Rover Evoque. Rear Suspension

4.

Range Rover Evoque. Rear Suspension

Installation

1. CAUTION: Only tighten the nut and bolt finger tight at this stage.

Range Rover Evoque. Rear Suspension

2. CAUTION: Only tighten the nut and bolt finger tight at this stage.

Range Rover Evoque. Rear Suspension

3. CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.

Support weight of vehicle on a jack at the rear hub.

4. Torque: 175 Nm

Range Rover Evoque. Rear Suspension

5. Torque: 175 Nm

Range Rover Evoque. Rear Suspension

6. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

READ NEXT:

Rear Lower Arm AWD

Special Tool(s) 205-857 Remover, Halfshaft Removal CAUTION: LH illustration shown, RH is similar. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

Rear Stabilizer Bar

Removal NOTES: Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure

Wheel Knuckle

Special Tool(s) 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow halfshaf

SEE MORE:

Intake Air Distribution and Filtering - GTDi 2.0L Petrol

Intake Air Distribution and Filtering - Component Location COMPONENT LOCATION Purge hose from charcoal canister Clean air purge hose Clean air inlet ducts Camshaft cover vent pipe connection Sound generator duct Sound generator Air cleaner housing Dirty air intake duct Sound generator hos

Wheels and Tires

Wheel and Tire Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. NOTE: Make sure that the component is installed to the position noted on removal. Installation 1. CAUTION:

© 2011-2026 Copyright www.rrevoque.org