Range Rover Evoque: Government end users
If the DATABASE is for a region of North
America and is being acquired by or on behalf
of the United States government or any other
entity seeking or applying rights similar to
those customarily claimed by the United States
government, the DATABASE is licensed with
‘limited rights’.
Utilization of the DATABASE is subject to the
restrictions specified in the ‘Rights in Technical
Data and Computer Database’ clause at DFARS
252.227–7013, or the equivalent clause for
non-defence agencies. Manufacturer of the
DATABASE of North America is NAVTEQ
Corporation, 10400 W. Higgins Road, Suite
400, Rosemont, Illinois 60018, USA.
READ NEXT:
Hereby, DENSO CORPORATION
declares that this DN-NS-019 is in
compliance with the essential
requirements and other relevant provisions of
Directive 1999/5/EC.
Avoid exposing the fuel
gasses to any
potential sources of ignition as the
resulting fire and explosion may
cause serious injuries and/or death.
Switch off the engine when refuelling,
as it is
SEE MORE:
Removal
NOTES:
The fender apron panel front reinforcement is manufactured from RP220 and
mild steel.
The panel is serviced less its weld studs
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on an
approved alignment jig.
2. The front side member and fender a
Adjust the head restraint so
that the
top of the head restraint is above the
centre line of the head. An incorrectly
adjusted head restraint increases the
risk of death or serious injury in the
event of a collision.
Do not drive, or carry passengers with
the head restraints removed from
o
© 2011-2026 Copyright www.rrevoque.org
