Range Rover Evoque: Overhead Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. CAUTION: Take extra care not to damage the edges of the component.
2.
3. NOTE: Do not disassemble further if the component is removed for access only.
4. CAUTION: Take extra care not to damage the wiring harnesses.
Take precautions to avoid any electrostatic charging, which could damage this comopnent.
5.
6. CAUTION: Take extra care not to damage the wiring harnesses.
7.
8.
Installation
1. CAUTION: Take extra care not to damage the wiring harnesses.
NOTE: If installing a new overhead console, make sure the original blanking plugs are installed to the new component.
To install, reverse the removal procedure.
Glove Compartment
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3.
4. NOTES:
Left-hand shown, right-hand similar.
The step must be carried out on both sides.
5.
6. Torque: 4 Nm
7.
8.
9. NOTE: Glove compartment shown removed for clarity.
10. Torque: 6 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Floor Console Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: The procedure must be carried out on
both sides.
NOTE: LH illustration shown, RH is similar.
T
Locks, Latches and Entry Systems
Principle of Operation
For a detailed description of the locks, latches and entry systems and
operation, refer to the relevant Description and
Operation section of the workshop manual REFER to: Handl
SEE MORE:
Rear Wheelhouse Outer
Removal
NOTES:
It is necessary to remove the inner quarter panel to enable removal and
installation of the rear wheelhouse outer.
The rear wheelhouse outer is manufactured from mild steel.
This method describes the LH rear wheelhouse outer, the RH side is similar.
1. The rear wheelhouse outer is
Rear Shock Absorber Vehicles With: Dynamic
Suspension
General Equipment
Suspension Spring Compressor
Vise
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations section.
Always follow the spring compressor manufacturer's instructions.
The spring is under extreme te
