Range Rover Evoque: Rear lamp bulbs

1. Remove the two fixings.

1. Remove the two fixings.

2. Direction indicator.

3. Reversing lamp

Turn the relevant bulb holder counter clockwise and pull to remove from the lamp unit. Grip the holder then press the bulb into the holder and turn counter clockwise to release the bulb. Pull the bulb up to remove.

READ NEXT:

 Rear fog lamp

Access to the rear fog lamp requires special tools and should be undertaken only by a qualified technician. If in doubt, consult your Land Rover Dealer/Authorised Repairer.

 Cleaning the exterior

Remove any heavy deposits of mud and dirt with a hose before washing the vehicle. Never aim a hose water jet directly at the engine air intake, heater air intakes, body seals or at any compone

 Using white spirit

Stubborn stains such as tar spots and grease may require the use of white spirt. After use, ensure the area is washed immediately with warm soapy water to remove all traces of the spirit.

SEE MORE:

 Exterior Lighting - Component Location

COMPONENT LOCATION Instrument cluster Hazard flasher switch Rain/Light sensor Rear height sensor (Xenon headlamps only) Side turn signal indicator lamp Headlamp leveling control module CJB (central junction box) Reverse lamp switch Front height sensor (Xenon headlamps only) Stop lamp swi

 Transfer Case Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: AWF21 6-Speed Automatic Transmission

Special Tool(s) 100-012 Slide Hammer 307-594 Installer, Seal 308-005 Remover, Axle oil seal Removal NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2.

© 2011-2026 Copyright www.rrevoque.org