Range Rover Evoque: Timing Chain

Removal

NOTES:

Some illustrations may show the engine removed for clarity.

Some variation in the illustrations may occur, but the essential information is always correct.

1. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

3. Refer to: Timing Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).

4.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

5.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

6.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

7.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

8. CAUTIONS:

Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning.

Note the fitted position of the component prior to removal. Do not disassemble further if removed for access only

Range Rover Evoque. Engine - GTDi 2.0L Petrol

9.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

Installation

1. CAUTION: Install a new friction washer.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

2. CAUTIONS:

Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning.

Make sure that these components are installed to the noted removal position.

Only tighten the bolts finger-tight at this stage.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

3.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

4. Torque: 10 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

5. Torque: 10 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

6. CAUTION: Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning. Torque: 72 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

7. Refer to: Timing Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).

8. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

READ NEXT:

 Timing Cover

Special Tool(s) 303-021 Engine support bracket JLR-303-1591 Lifting Bracket, Engine - Rear Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustratio

 Valve Cover

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Engine - Removal and Installation

Removal Special Tool(s) 205-857 Remover, Halfshaft 1. Refer to: Battery Tray (414-01 Battery, Mounting and Cables, Removal and Installation). 2. Refer to: Air Conditioning (A/C) System Recovery, Evacu

SEE MORE:

 Transmission Vehicles With: M66 6-Speed Manual Transmission FWD - Removal

Removal Special Tool(s) 205-857 Remover, Halfshaft 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine General Equipment Transmission jack 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. Refe

 Safety information

Some tyre damage may only be partially sealed, or may not seal at all, depending on the amount and type of damage. Any loss of tyre pressure can seriously affect vehicle safety. Do not use the tyre repair kit if the tyre has been damaged by driving while under inflated. Only use the tyre re

© 2011-2026 Copyright www.rrevoque.org