Range Rover Evoque: Cruise eco data

Diesel only

When enabled, a CO2 emission indicator is

When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEHICLE INFORMATION AND SETTINGS MENU.

READ NEXT:

 Stability control

 Dynamic stability control (DSC)

DSC is automatically enabled each time the engine is started, and is automatically enabled by some of the Terrain response special programs. The vehicle is not designed for cornering at the sa

 Dsc warning lamp

The amber DSC warning lamp in the instrument panel illuminates briefly when the ignition is switched on and extinguishes when the engine is started. If the lamp flashes while driving, the DSC

SEE MORE:

 Anti-Lock Control - Traction Control FWD

Component Location NOTE: RHD (right-hand drive) installations shown; LHD (left-hand drive) installations similar. COMPONENT LOCATION - SHEET 1 OF 2 RH (right-hand) front wheel speed sensor RH rear wheel speed sensor LH (left-hand) rear wheel speed sensor LH front wheel speed sensor Integrate

 Transfer Case Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: M66 6-Speed Manual Transmission AWD

Special Tool(s) 100-012 Slide Hammer 303-1300 Remover, Crankshaft Seal 303-538 Remover/Installer, Crankshaft Oil Seal 307-594 Installer, Seal 307-595 Installer, Intermediate Shaft Seal 308-615 Remover, Seals Removal NOTE: Some variation in the illustrations may occur, but the essential information

© 2011-2025 Copyright www.rrevoque.org