Range Rover Evoque: Dual view selection

When the ignition is switched on or the audio unit is turned on after being turned off, single view mode will be the default view.

To select dual view, press the dual view hard key on the fascia surround. See 111, AUDIO/VIDEO CONTROLS.

Press again to display the dual view Options menu. From here, a change can be made to the viewing source or dual view can be cancelled.

If TV or a video format source were being viewed previously, the same source will be displayed.

READ NEXT:

 Dual view control menu

Dual view control menu 1. Select to cancel dual view and revert to the menu for the current video source (TV, DVD). Note: The preview screen will be deactivated if the vehicle is moving. 2. Se

 Dual view tv operation

If you would like to change the TV programme while the vehicle is moving, there are two methods available; 1. Press the dual view hardkey to display the control menu. Select an alternative channe

 Dual view video operation

When the video programme begins play, a root menu with information about the video programme and its content will be displayed on screen. Note: Information and style may vary due to differing vid

SEE MORE:

 Instrument Cluster (IC)

 CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.  NOTES: If the control module or a component

 Instrument Panel TD4 2.2L Diesel

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Make the SRS system safe. Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation). 2. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery,

© 2011-2025 Copyright www.rrevoque.org