Range Rover Evoque: Headlamps

Moving the nearside headlamp unit to access bulbs;

1. Remove the two plastic fixings.

1. Remove the two plastic fixings.

2. Pull the tube up to release from the air box.

This will allow more room for manoeuvrability.

3. Remove the four grille fixings.

4. Remove the two retaining bolts.

5. At the rear of the headlamp unit, pull up on the T grip release mechanism and hold while sliding the headlamp unit forward 40mm.

Moving the offside headlamp unit to access bulbs;

1. Remove the four grille fixings.

1. Remove the four grille fixings.

2. Remove the two retaining bolts.

3. Remove the fixing then move the filler tube rearwards. This will allow more room for access to the bulb holders.

4. At the rear of the headlamp unit, pull up on the T grip release mechanism and hold while sliding the headlamp unit forward 40mm.

Removing a headlamp bulb;

1. At the back of the headlamp unit, remove

1. At the back of the headlamp unit, remove the cover. Turn it counter clockwise to release.

2. The back of the bulb unit will now be exposed. Pull down on the electrical connector to release it from the bulb unit.

3. Turn the retaining collar counter clockwise to release the bulb. Remove the bulb unit from the housing.

READ NEXT:

 Direction indicator and side lamp bulbs

Removing the nearside bulbs; To gain more room for accessibility, follow steps 1 and 2 for moving the nearside headlamp unit. 1. At the back of the headlamp unit, remove the indicator bulb hous

 Rear lamp bulbs

1. Remove the two fixings. 2. Direction indicator. 3. Reversing lamp Turn the relevant bulb holder counter clockwise and pull to remove from the lamp unit. Grip the holder then press the bulb i

 Rear fog lamp

Access to the rear fog lamp requires special tools and should be undertaken only by a qualified technician. If in doubt, consult your Land Rover Dealer/Authorised Repairer.

SEE MORE:

 Garage door transceiver

Do not use the transceiver with any garage door opener that lacks the safety stop and reverse feature as required by safety standards. When programming the transceiver to a garage door opener or entry gate, ensure the area is clear. This will prevent potential harm or damage as the gate o

 Octane rating

The minimum octane rating for fuel used is 95 RON. The vehicle will run on lower ratings, but it may cause pronounced engine knock or pinking. If the pinking is severe it can cause damage to the engine, fuel and emission control systems. Note: Occasional, light, engine knock experienced while

© 2011-2026 Copyright www.rrevoque.org