Range Rover Evoque: Operating the tailgate
Ensure there is minimum space
of 1.0M
(39 in) above the rear of vehicle before
operating the tailgate. Insufficient space
may result in damage to the vehicle.
Do not operate the tailgate
if a cycle
rack is fitted to the tailgate. Remove any
cycles and/or racks before operating
the tailgate.
There are two types of tailgate, powered and manual.
Both types of tailgate can be released using:
- the appropriate button on the Smart Key,
- the internal release switch,
- the external release switch on the tailgate.
Note: The tailgate will not open if the vehicle is travelling at or above approximately 5km/h (3.1mph).
Note: When using the external release switch, all doors must be unlocked and the gear selector in Park (P) position.
Note: If the Smart Key is inadvertently left inside the luggage compartment and the vehicle is locked and the alarm set, an audible warning will sound and the tailgate will re-open after three seconds.
READ NEXT:
Powered tailgate operation
1. Press to open the powered tailgate.
2. Press and release to close the powered
tailgate.
After the tailgate has opened to its set height, it
can be manually raised or lowered. If the
tailgate
Powered tailgate opening height
The maximum opening height can be set as
required. This is useful in parking areas with
low ceiling heights or just for ease of use.
1. Open the tailgate to the position which you
want to set as t
Programmed position loss
The powered tailgate may lose its position
memory if there are multiple object detections
or if battery voltage is low. Powered operation
may be inhibited. To reset the tailgate;
1. Manually close
SEE MORE:
Fender Apron Lower Panel
Removal
NOTES:
The fender apron lower panel is manufactured from mild steel.
The panel is serviced less its weld studs
This method describes the LH fender apron lower panel, the RH side is similar.
1. The fender apron lower panel is replaced in conjunction with:
Front bumper cover
Front bumper
Glass Roof Panel Blind
Removal
CAUTION: When removing and installing the glass roof panel blind, extreme
cleanliness must be observed at all
times.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. NOTE: The procedure must be carried out on both sides.
Refer to: A-Pillar Trim Panel
