Range Rover Evoque: Overhead Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. CAUTION: Take extra care not to damage the edges of the component.
2.
3. NOTE: Do not disassemble further if the component is removed for access only.
4. CAUTION: Take extra care not to damage the wiring harnesses.
Take precautions to avoid any electrostatic charging, which could damage this comopnent.
5.
6. CAUTION: Take extra care not to damage the wiring harnesses.
7.
8.
Installation
1. CAUTION: Take extra care not to damage the wiring harnesses.
NOTE: If installing a new overhead console, make sure the original blanking plugs are installed to the new component.
To install, reverse the removal procedure.
Glove Compartment
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3.
4. NOTES:
Left-hand shown, right-hand similar.
The step must be carried out on both sides.
5.
6. Torque: 4 Nm
7.
8.
9. NOTE: Glove compartment shown removed for clarity.
10. Torque: 6 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Floor Console Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: The procedure must be carried out on
both sides.
NOTE: LH illustration shown, RH is similar.
T
Locks, Latches and Entry Systems
Principle of Operation
For a detailed description of the locks, latches and entry systems and
operation, refer to the relevant Description and
Operation section of the workshop manual REFER to: Handl
SEE MORE:
Sand
This program should be used for
terrain which is predominantly soft
dry sand or deep gravel.
Note: If the vehicle is unable to gain traction in
extremely soft, dry sand, switching DSC off
may help. DSC should be switched on again as
soon as the difficulty is overcome.
If the sand to be cros
Starting a disabled vehicle using a starting aid
To start the vehicle using a starting aid or a
slave battery, follow the instructions in the
sequence given.
1. Connect the positive (Red) booster cable to
the positive (+) battery terminal of the
discharged battery.
2. Connect the negative (Black) booster cable
to the vehicle earth point.
3
