Range Rover Evoque: Valet
Selection:
Valet mode allows the vehicle to be driven and locked by a parking attendant, without giving access to the luggage compartment. Valet mode also prevents operation of the touch screen, to prevent access to telephone numbers or navigation addresses.
From the Home menu, select Valet: Enter a memorable four digit Personal identification Number (PIN). On completion, touch the OK soft key.
If you wish to cancel the PIN, select Delete.
If the PIN is cancelled, or incorrectly entered, you will be prompted to enter the PIN again.
Valet mode activated is displayed to indicate that the PIN has been accepted.
The luggage compartment is now securely locked in Valet mode and the Valet mode On screen is displayed.
Deselection:
When you re-enter the vehicle, touch the Valet button to view the Valet mode screen.
Enter your four digit PIN and touch the OK button.
Valet mode deactivated is displayed to indicate that your PIN has been accepted.
- The luggage compartment will return to the previously set security requirement.
- The touch screen will be enabled.
Note: If the PIN is forgotten, Valet mode can only be deactivated by your Dealer/Authorised Repairer.
READ NEXT:
Extra features
There are more features available than can be
displayed at one time. This menu allows the
selected features to be displayed, for example:
- Ambient lighting: While the headlamps are
turned on, sel
Touch screen care
Do not use abrasive cleaners
on the
touch screen. For approved cleaning
products, contact your Dealer/
Authorised Repairer.
The touch screen and inner bezel must be kept
clean to maintain opti
SEE MORE:
Programmed position loss
The powered tailgate may lose its position
memory if there are multiple object detections
or if battery voltage is low. Powered operation
may be inhibited. To reset the tailgate;
1. Manually close the tailgate.
2. Press a release switch.
3. Allow the tailgate to power fully open or to
the pre
Transmission Vehicles With: M66 6-Speed
Manual Transmission FWD - Removal
Removal
Special Tool(s)
205-857
Remover, Halfshaft
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
General Equipment
Transmission jack
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refe
