Range Rover Evoque: Block Heater
Removal
1. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
2. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).
3. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
4. NOTE: Measure and mark a 70mm section of the pipe using the clamp as a guide.
5. NOTE: Discard the bolt and clamp.
Installation
1. Torque: 20 Nm
2. Torque: 6 Nm
3. NOTE: Using a suitable tool, cut a 70mm gap from the coolant pipe.
4. Torque: 3 Nm
5. CAUTION: Protect the surrounding paintwork and body from the movement of the cutting blades.
NOTE: Following the indent on the bumper and using a suitable tool, cut a 26mm hole in the front bumper cover.
6.
7. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
8. CAUTION: Make sure the retaining clip is secured correctly.
9.
10. NOTE: Make sure all ground connections are correctly installed. Torque: 10 Nm
11. Fill the engine coolant and test the block heater for correct operation.
Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
12. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).
READ NEXT:
Fuel Charging and Controls - Component Location, System Operation and Component Description
Component Location
COMPONENT LOCATION
Overview
OVERVIEW
The 2.0L GTDi engine is equipped with a high-pressure direct injection system
controlled by the ECM (engine control
module). A high-pressure f
Throttle Body
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some illustrations may show the engine removed for clarity.
1. WARNING: Make sure to support the vehicle with axle sta
SEE MORE:
Exterior Front/Rear Door Handle
Exterior Front Door Handle
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
Make sure the door window glass is in the fully closed position.
1. Refer to: Front Door Tri
Navigation System
Navigation System
Principles of Operation
NOTE: This navigation system is installed in selected Asia market vehicles
only.
For a detailed description of the navigation system, refer to the relevant
Description and Operation section of the
workshop manual. REFER to: (415-01 Information and Entertai
