Range Rover Evoque: Bulb specification chart
Before attempting to replace
a bulb,
ensure that both the affected lamp and
the vehicle's ignition, are turned off. If
the circuit remains live, a short circuit
can occur which may damage the
vehicle's electrical system.
Note: LED bulbs can be replaced only by a
Land Rover Dealer/Authorised Repairer.

READ NEXT:
1. Steering column backup transmitter.
2. Front cockpit transmitters.
3. Front exterior door handle transmitters.
4. Roof keyless receiver.
5. Floor console front transmitter.
6. Rear exterior
SEE MORE:
Special Tool(s)
100-012
Slide Hammer
205-872
Installer, Transfer Case Seal
308-615
Remover, Seals
308-617
Depth Drill, Seal Remover
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
alway
Exhaust System - GTDi 2.0L Petrol
Lubricants, Fluids, Sealers and Adhesives
* Apply to area around sensor threads prior to attempting to remove sensor
General Specification
Torque Specifications
** It is not appropriate to either fit or remove these fixings using air
tools due to a risk of cold
© 2011-2026 Copyright www.rrevoque.org - 0.0042
