Range Rover Evoque: Decreasing cruise speed

To reduce cruising speed, press and hold control (4). Release the switch when the desired speed is reached, the new speed will be set and maintained.

The set speed can be decreased in steps of 2km/h (1mph), by briefly pressing control (4).

READ NEXT:

 Suspending and resuming cruise control

Suspend cruise control with a single press of control (3). To resume cruise control at the previous set speed, press control (2). RES (2) should be used only if the driver is aware of the set

 Automatic switch off

Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed. - The brake pedal is pressed. - Speed falls below 30km/h (18mph). - Neutral, Park

 Cruise eco data

Diesel only When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEH

SEE MORE:

 Rear Disc Brake

General Specification Torque Specifications * New nuts/bolts must be installed Brake Pads Removal WARNING: Brake pads must be renewed in axle sets only. Failure to follow this instruction may result in braking efficiency being impaired. CAUTION: LH illustration shown, RH is similar. 1. Connect th

 Wheel changing safety

Before raising the vehicle or changing a wheel, ensure that you read and comply with the following warnings. Always find a safe place to stop, off the highway and away from traffic. Ensure that the vehicle and jack are both on firm level ground. Apply the parking brake. Engage Park (P) on

© 2011-2026 Copyright www.rrevoque.org