Range Rover Evoque: Dual view selection

When the ignition is switched on or the audio unit is turned on after being turned off, single view mode will be the default view.

To select dual view, press the dual view hard key on the fascia surround. See 111, AUDIO/VIDEO CONTROLS.

Press again to display the dual view Options menu. From here, a change can be made to the viewing source or dual view can be cancelled.

If TV or a video format source were being viewed previously, the same source will be displayed.

READ NEXT:

 Dual view control menu

Dual view control menu 1. Select to cancel dual view and revert to the menu for the current video source (TV, DVD). Note: The preview screen will be deactivated if the vehicle is moving. 2. Se

 Dual view tv operation

If you would like to change the TV programme while the vehicle is moving, there are two methods available; 1. Press the dual view hardkey to display the control menu. Select an alternative channe

 Dual view video operation

When the video programme begins play, a root menu with information about the video programme and its content will be displayed on screen. Note: Information and style may vary due to differing vid

SEE MORE:

 Headphones

The volume control for each set of headphones is adjusted on the headphones. Press the channel selector button to cycle through available channels. Select the channel appropriate for the required screen. Note: These headphones are not intended for use by the driver or outside the vehicle. Not

 Rds-tmc display

When a TMC signal is received the icon in the top left of the screen will appear green. If a TMC signal is not being received, the icon will be shown with a bar through it. The system will inform the driver of any reported roadworks, narrow road, contraflow, accidents, slippery road, diversion

© 2011-2026 Copyright www.rrevoque.org