Range Rover Evoque: Engine starting: manual transmission
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Engine starting: manual transmission
Note: Do not press the accelerator pedal when starting the engine.
1. A valid Smart Key must be inside the vehicle.
2. Fully depress the clutch pedal.
3. Press and release the start button. For diesel engined vehicles there may be a delay while the glow plugs warm up, then the engine will crank automatically until it starts.
READ NEXT:
If the engine fails to start
Note: If the engine fails to crank when the
START/STOP button is pressed and there has
been a recent collision, seek qualified
assistance.
If the engine fails to crank, or fails to start,
consult
Switching off the engine
Before switching off the engine, ensure that the
vehicle is parked safely with the park brake
applied.
1. Select P for automatic transmission, or
neutral for manual transmissions.
Note: If any ot
Switching off the engine with the vehicle moving
It is not advisable to switch
off the
engine while the vehicle is moving.
However, should such a situation
arise, then the following procedure
applies.
- Press and hold the engine START/STOP
SEE MORE:
Halfshaft Seal RH Vehicles With: M66
6-Speed Manual Transmission FWD
Special Tool(s)
303-1300
Remover, Crankshaft Seal
307-594
Installer, Seal
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Front Halfshaft RH - FWD (205-04 Front Drive Halfshafts,
Removal and Installation).
3. CAUTIONS:
Make sure that
Manual Transmission FWD
Component
Location
COMPONENT LOCATION
Manual transmission
Selector lever assembly
Overview
OVERVIEW
The M66EH50 manual transmission is a 6 speed unit manufactured by Getrag-Ford
in Cologne, Germany. The transmission
is a highly compact 4 shaft design, incorporating the front final drive gear.
© 2011-2026 Copyright www.rrevoque.org - 0.0042
