Range Rover Evoque: Front Lower Arm

Removal

NOTES:

Some variation in the illustrations may occur, but the essential information is always correct.

Front wheel drive transmission illustrations shown, all wheel wheel drive transmission is similar.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

3.

Range Rover Evoque. Rear Suspension

4.

Range Rover Evoque. Rear Suspension

Installation

1. CAUTION: Only tighten the nut and bolt finger tight at this stage.

Range Rover Evoque. Rear Suspension

2. CAUTION: Only tighten the nut and bolt finger tight at this stage.

Range Rover Evoque. Rear Suspension

3. CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.

Support weight of vehicle on a jack at the rear hub.

4. Torque: 175 Nm

Range Rover Evoque. Rear Suspension

5. Torque: 175 Nm

Range Rover Evoque. Rear Suspension

6. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

READ NEXT:

 Rear Lower Arm AWD

Special Tool(s) 205-857 Remover, Halfshaft Removal CAUTION: LH illustration shown, RH is similar. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

 Rear Stabilizer Bar

Removal NOTES: Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure

 Wheel Knuckle

Special Tool(s) 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow halfshaf

SEE MORE:

 Passenger Seat Cushion Heater Mat

Removal WARNINGS: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing any air bag supplemental restraint system (SRS) components. To deplete the backup power supply energy, disconnect the battery ground cable and wait

 Blower Motor LHD AWD/LHD FWD

Special Tool(s) 412-140 Remover/Installer, Blower Motor Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is always correct. 1. NOTE: The recirculation blend door must be closed in order for

© 2011-2026 Copyright www.rrevoque.org