Range Rover Evoque: Interior lights locations
Interior lights locations
1. Sun visor lamps. Illuminates when the vanity mirror is opened.
2. Map reading lamps. Move a finger close to (or touch) the relevant lens to switch on/off.
Note: If you are wearing gloves, it may be necessary to touch the lens to operate the lamps.
3. Front interior lamp. Illuminates when the doors are unlocked and extinguishes 60 seconds after all doors are closed, when the engine starts or when the vehicle is locked. Move a finger close to (or touch) the lens to switch on and off manually.
Touch the lens for two seconds to deactivate/activate automatic illumination.
4. Glove box lamp. Illuminates when the glove box is opened.
5. Footwell lamps. Illuminates when the doors are unlocked and extinguishes 60 seconds after all doors are closed, when the engine starts or when the vehicle is locked.
6. Rear interior/reading lamps. Illuminates when the doors are unlocked and extinguishes 60 seconds after all doors are closed, when the engine starts or when the vehicle is locked. Press the switch to switch on and off manually. Touch the front courtesy lamp lens for approximately 2 seconds to deactivate/activate automatic illumination of the rear interior lamps.
7. Luggage compartment lamp. Illuminates when the tailgate is opened.
READ NEXT:
Interior lights intensity
While the exterior lamps are turned on,
intensity of interior lights can be adjusted. See
248, CONTROLS, Interior illumination control.
Ambient lighting
The LED ambient lighting can be adjusted for
colour and intensity via the touch screen. The
exterior lamps must be turned on while
changes are being made via the touch screen.
See 104, TOUCH SCREE
SEE MORE:
Rear Seat Backrest Cover 3-Door
Removal
NOTES:
This procedure covers the removal and installation of both rear seat
backrests and the LH rear seat backrest cover.
The RH rear seat backrest cover is similar. All notes and cautions must be
followed strictly to avoid any chance of NVH or
failure of the rear seat backrests.
5-door
Headlamp Assembly
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2.
3.
4. NOTE: Some components shown removed for
clarity.
5.
6.
7.
8.
9. Remove all bumper lower fixing to assist the
