Range Rover Evoque: Oil check preparation

Prior to checking the oil level ensure that: - The vehicle is on level ground.

- The engine oil is cold.

Note: If it is necessary to check the oil level when the engine is hot, switch off the engine and let the vehicle stand for 5 minutes to allow the oil to drain back into the sump. Do not start the engine.

The oil level can then be checked as follows: 1. Withdraw the dipstick and wipe the blade clean with a lint free cloth.

2. Fully re-insert the dipstick and withdraw again to check the oil level.

As a general guide, if the oil level on the dipstick: - Is nearer to the upper mark or notch than the lower, do not add oil.

- Is nearer to the lower mark or notch than the upper, add 0.5 litre (1 pint) of oil.

- Is below the lower mark or notch, add for the diesel engine, 1.5 litre (2.6 pints) of oil and for the petrol engine, 0.8 litre (1.4 pints) of oil. Re-check the level after a further 5 minutes.

READ NEXT:

 Topping up the engine oil

Your vehicle warranty may be invalidated if damage is caused by using oil that does not meet the required specification. Failure to use an oil that meets the required specification could cause

 Engine oil specification

It is important that the correct oil specification is used. Vehicles fitted with a diesel particulate filter (DPF) must use the specified oils otherwise significant engine damage will occur. Speci

 Coolant level check

Running the engine without coolant will cause serious engine damage. The coolant level in the expansion tank should be checked at least weekly (more frequently in high mileage or arduous operat

SEE MORE:

 Tyre care

Do not drive the vehicle if a tyre is damaged, excessively worn, or incorrectly inflated. Avoid contaminating the tyres with vehicle fluids as they may cause damage to the tyre. Avoid spinning the wheels. The forces released can damage the structure of the tyre and cause it to fail. If w

 Transfer Case Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: M66 6-Speed Manual Transmission AWD

Special Tool(s) 100-012 Slide Hammer 303-1300 Remover, Crankshaft Seal 303-538 Remover/Installer, Crankshaft Oil Seal 307-594 Installer, Seal 307-595 Installer, Intermediate Shaft Seal 308-615 Remover, Seals Removal NOTE: Some variation in the illustrations may occur, but the essential information

© 2011-2026 Copyright www.rrevoque.org