Range Rover Evoque: Replacing remote control batteries

Replacing remote control batteries
With the back of the remote control facing
upwards, use a coin or similar implement to
rotate the battery cover. Lift the cover off to
reveal the battery compartment. Remove the
old battery and, ensuring that the correct
polarity is maintained, insert a replacement 3.3
volt, CR1/3N battery. Replace the cover and
rotate it to lock it closed.
READ NEXT:
A maximum of three controls can be
programmed to each vehicle. Contact your
Land Rover dealer to purchase additional units
and have them programmed to your vehicle.
Cup holders and storage
1. Glovebox.
2. Inside the glovebox is a drop down storage
area for the Owner’s Handbook pack.
3. Cubby box.
4. Sliding top to reveal cup holders.
Do not drink, or u
SEE MORE:
If reverse gear is selected while the front
wipers are operating, the rear wiper will start
automatically and continue as long as reverse
gear is selected. The wipe interval is dependent
on the front wipers setting.
If reverse gear is selected while the rear wiper
control is in the INT positio
Removal
NOTES:
The rocker panel is manufactured from mild steel.
Some of the butt joints must be MIG brazed due to the location of boron
reinforcements.
1. This procedure
identifies the
method for the
replacement of
the rocker
panel in full.
The graphic
and table
identify
possible
alternative
sec
© 2011-2026 Copyright www.rrevoque.org
