Range Rover Evoque: Selecting valet mode
Valet mode allows the vehicle to be driven, e.g.,
by a parking attendant, but leaves the tailgate
locked and restricts use of the touch screen.
This prevents access to telephone numbers,
navigation addresses and audio system
settings.
From the Home menu, select Valet:
Enter a four digit Personal identification
Number (PIN) (personally chosen). On
completion, touch the OK soft key.
If you wish to cancel the PIN, select Delete.
After entering the PIN, you will be prompted to
enter the PIN again. Enter the same PIN and
touch OK to confirm.
A pop-up screen is displayed, confirming your
vehicle is now in Valet mode.
READ NEXT:
The interior protection feature of the full alarm
system may be temporarily disabled via Alarm
sensors in the Vehicle Settings menu. See 56,
VEHICLE INFORMATION AND SETTINGS
MENU.
Note: If the in
In certain markets, a battery backed sounder is
fitted. This device will sound if it or the vehicle
battery is disconnected while the security
system is armed.
The tilt sensor detects any change to the
vehicle’s angle to the ground. When the alarm
is armed and the vehicle is double locked, any
change in the vehicle’s angle will activate the
tilt alar
SEE MORE:
Headlamp Control Module B (HCMB)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault and may also cause additional faults in
the vehicle being checked and/or the donor
vehicle.
NOTES:
If
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: To avoid accidental deployment, the restraints
control module backup power supply must be depleted. Wait at least
two minutes after disconnecting the battery ground cable(s) before
commencing any repair or ad
© 2011-2025 Copyright www.rrevoque.org
