Range Rover Evoque: To erase all programming
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / To erase all programming
For first time programming, ensure that the engine is switched off: 1. Ensure that the ignition is on (but with the engine switched off).
2. Press and hold the two outer HomeLink buttons. Keep the buttons pressed until the indicator lamp begins to flash (this will take approximately 20 seconds), then release the buttons.
All memories in HomeLink have now been cleared.
Note: Do not perform this procedure when programming the additional garage door opener buttons.
READ NEXT:
Entry gate programming
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin
Information and assistance
It is recommended that when
you sell or
dispose of the vehicle, the programmed
HomeLink buttons be erased for
security purposes.
For information on the range of available
compatible products or
Instrument panel
Instrument panel
1. Speedometer.
2. Driver Information Centre (message centre).
3. Tachometer.
4. Temperature gauge
Serious engine damage can
occur if
the vehicle is driven while the
engin
SEE MORE:
Epb manual use
Epb manual use
1. To apply the parking brake, with the vehicle
stationary, pull up the lever and release it.
The parking brake warning
lamp will illuminate. It is
important to confirm that the
lamp is continuously illuminated (not
flashing), as this indicates the brake has
been correctly
Conditions preventing automatic engine stop
The engine will not automatically stop if:<>
- the external temperature is below approximately 0°C (32°F)
- the external temperature is above approximately40°C (104°F)
- engine has not reached operating temperature
- driver’s seat belt is not fastened
- driver’s door is not fully
© 2011-2025 Copyright www.rrevoque.org
